Raven Cruizer II Betreibershandbuch PDF herunterladen (Seite 76)

Chapter 9

70 SmartBoom and SmartRow Installation and Operation Manual

SmartBoom Modes

The available modes for operating SmartBoom are:

• Standard SmartBoom Job

• SmartBoom Job with No Spray Zone

• SmartBoom Job with Field Boundary

• SmartBoom Job with Field Boundary and No Spray Zone

Standard SmartBoom Job

As sections enter previously sprayed areas, SmartBoom automatically turns that section OFF. When

the section leaves the previously sprayed area, SmartBoom automatically turns the section back ON.

The standard field boundary Tools are used while operating in Standard SmartBoom Mode.

No Spray Zone Mapping Mode

No Spray zones may be created and around any areas in which product application should be

avoided, such as waterways or around well heads.

For example, as the vehicle crosses into a no spray zone, SmartBoom automatically shuts off any

section that enters the no spray zone while other sections remain enabled. As the sections re-enter un-

sprayed zones, SmartBoom automatically toggles product application back on.

Field Boundaries

Field Boundaries within a SmartBoom enabled Job automatically create a zone map based upon the

completed boundary.

SmartBoom assigns a minimum of three implement widths outside of the completed field boundary of a

spray zone.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 97 98

Keine Kommentare

Raven Cruizer II Betreibershandbuch Seite 76