Raven Cruizer II Betreibershandbuch PDF herunterladen (Seite 64)

Chapter 8

58 SmartBoom and SmartRow Installation and Operation Manual

Baud Rate Screens

To get to the Baud Rate screens, press from the Distance Units screen.

The Baud Rate screens allow you to edit the baud rate for ports A through D. The setting for Port B is

used to control the baud rate for the port on the SmartBoom/SmartRow Control Box labeled “DGPS”

and port C is normally connected to a product control console on the connector labeled “CONSOLE.”

The port C baud rate is only editable if the Console Port setting is set to “NONE.”

Press to change from Port A to B, etc.

Press the key to change the Baud Rate setting. The setting will begin blinking to indicate you are

in edit mode. Use the or key to toggle between possible values (4800, 9600, 19200, 38400,

57600, and 115200). Press the key again to finish editing.

Note: If the SmartBoom/SmartRow controller flashes “Console Port!” rather than entering the

edit mode, you must first change the console port to “None.” See the Console Port Screen

section for more information.

Port A Baud Rate

19200 bps

RAVEN

HOME

INDUSTRIES

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 97 98

Keine Kommentare

Raven Cruizer II Betreibershandbuch Seite 64